Bryston SP2 Manuel d'utilisateur

SP2PREAMP/PROCESSORO W N E R ’ S M A N UA L

SP2 Remote Control continued... 1: SOURCE SELECT BUTTONSThese buttons are used to select the desired source. TV/SAT, DVD, CD, AUX, VCR, and TAPE func

SP2 PREAMP/PROCESSORmay have one.) IMPORTANT: When using the Pink Noise genera-tor within the SP2 for speaker level calibration, the salient point is

any system which you expect to effectively handle the low frequency dynamics of modern motion picture soundtrack sources such as DVD or HDTV feeds, an

SP2 PREAMP/PROCESSOR 4: Once you have selected the desired crossover frequency, press SELECT to exit this menu and return to the Speaker Config m

2: Next move the cursor to “LVL”. Hit ‘SELECT’ - You are now in the Level Trim Menu. 3: Move the cursor to the speaker(s) you want to change th

SP2 PREAMP/PROCESSOR ● ON: DTS-ES Matrix will be forced on for all DTS 5.1 channel input bit-streams, if the back channels are enabled. ● AUTO:

3: Panorama Mode extends the front stereo image to include the surround speakers for an exciting “wrap around” effect with side wall imaging. PLII

SP2 PREAMP/PROCESSORers. Surround Modes: HALL: This Sound Field Mode emulates a medium or large concert hall. It provides a longer reverber-ation time

17Power OFF . . . . . . . . . . . .000TV/SAT ...001DVD ...002CD ...

SP2 PREAMP/PROCESSOR18

1IMPORTANT SAFETY INSTRUCTIONSThe lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence

SP2_MANUAL_20060324 STP/19SUGGESTED SURROUND SPEAKER PLACEMENT

TABLE OF CONTENTS: 1. Safety Instructions & Warranty . . . . . . . . . . . 1 2. Contact information . . . . . . . . . . .

INTRODUCTIONCongratulations on your purchase of the Bryston SP2 pre-amplifier/processor. This product will pro-vide you with the finest available sign

SP2 PREAMP/PROCESSORSP2 FRONT PANEL CONTROLS & INDICATORS 1: POWER SWITCH (momentary) 2: STANDBY & INFRA-RED ACTIVITY INDICATOR 3: INFRA

6: MENU CONTROL BUTTONSSELThese three buttons labeled “”, “”, and “SEL” (SELECT) are used to con-trol the menu and setup functions dis-played on t

SP2 PREAMP/PROCESSORresents different mixing coefficients for the centre and surround channel signals. These will be detected by the SP2 and used to p

2. Move the cursor to the Optical Input (OPT1 or OPT2) you want to change the input assign-ment for. Hit ‘Select’. (see figure below) 3. Now

SP2 PREAMP/PROCESSOR 3. To change the source, use the “<” button. To toggle the trigger setting On or Off, use the “>” button. Hit ‘Select